Quality Heat Pump Service in the Wasatch Front region

Quality Heat Pump Repair and Replacement in the Wasatch Front region

Not only can an electric heat pump heat your home in the Wasatch Front region, it can cool it too. When compared to standard heating systems—like a gas furnace—you’ll also likely have a decreased heating and cooling bill.

Heat pumps function with an air handler, which distributes air throughout your home. While an air handler might have the appearance of a furnace, it doesn’t produce heat through fuel combustion. However, some air handler models may have secondary electric heating or cooling parts to help out the heat pump.

When you need heat pump service or heat pump repair, contact Barlow Service Experts. We can work on any model of heat pump. Our technicians are ACE-certified, which means they are among the finest in the HVAC industry when it comes to heating and cooling.

And like all our other work, our services for heat pump systems are backed by a one-year 100% Satisfaction Guarantee.*

Schedule an appointment
Poor Maintenance Can Cost You
An insufficiently maintained system can cost you. On average, an uncared-for heat pump can consume 10 to 25 percent more energy, according to the U.S. Department of Energy. It’s also more likely to malfunction or have a shorter life span.

When your HVAC system isn’t delivering the best home heating or isn’t working properly, try our troubleshooting tips below.

No heat. Check your thermostat is switched to “on” and “heat.” Next, make sure a circuit breaker hasn’t tripped. Recently replaced your thermostat? Make sure it’s a model appropriate for heat pumps and wired correctly.

Insufficient heat. Dirty filters, fan and coils can lower airflow and harm your system. Change your filter once a month, clean the unit’s coils and fan, and get rid of yard debris that may have accumulated around it. Your system may also have blocked air ducts, faulty valves or poor refrigeration flow.

Cold air instead of heat. Air from a heat pump won’t be as toasty as a forced air furnace. But if the air still seems too cold, set the thermostat to emergency heat and at least 5 degrees above the ambient temperature. If you get warm air, there may be a problem with your outdoor unit. Cold air means there’s probably an issue with your thermostat or air handler. Your system may have also gone into defrost mode to prevent icing up. If you see frost or ice on the outdoor coil, your unit may have a defective defroster timer or control module, or it could be low on refrigerant.

Heat pump turns on and off frequently. Swap out your air filter and then look at your thermostat, because it may need to be adjusted or need new batteries. If it’s cold and your system is on constantly, the thermostat may be set too high. Also, some heat pumps have trouble heating around 25 to 30 degrees Fahrenheit.

Rattling, grinding or squealing noises. If you hear rattling, try tightening the cover panels. If you hear grinding or squealing, stop using your system and call Barlow Service Experts. This could signal a serious problem.

Still having problems with your heat pump? Barlow Service Experts can help. Once we have your heat pump running, consider joining a routine membership plan that may help you avoid pricey repairs in the future. Routine service may also enhance your heat pump’s energy efficiency.
Should I Repair or Replace My Heat Pump?
When you’re faced with an expensive repair for your heat pump, it may be time to upgrade it.

Your system may need to be replaced when it:

Isn’t providing consistent heating and cooling

Needs constant repairs

Is driving up utility bills, even though you haven’t raised or lowered thermostat settings

Is more than 10 years old

When it comes to heat pump replacement or heat pump installation, Barlow Service Experts can help you find and install an energy-efficient model that’s right for your home. We can also help decide whether your air handler needs to be replaced too.

You can rely on a clean installation and a comprehensive system check before we leave. This makes sure your new system is heating and cooling properly and that you know how to use it.